Revision History

The following updates were made:

• Revised System Description in Introduction.

• Revised Anchor Bolts Placement and Clearances in Civil and Mechanical Design.

• Revised Wire Specifications in Electrical Design

• Corrected required voltage rating for Safety Hub and door interlock conductors in Wire Specifications.

• Added 100% recommended breaker sizing in Branch Circuits and Overcurrent Protection

• Revised Wire Terminal and Bus Bar Locations with wire length required to reach AC input and high power DC landings

Revised Electrical Design chapter; corrected AC continuous input current values and added circuit current and wire specification details.

The following updates were made:

• Replaced "high power ground" with "DC grounding"

• Updated Electrical Supply Requirements with GFPE requirement.

• Updated the Conduit Requirements section with a new AC input conduit specification and also remove reference to conduit outer diameter.

• Updated Wire Specifications section with new wire termination specifications.

The following updates were made:

• Revised System Description chapter

• Revised Civil and Mechanical Design chapter

• Revised Electrical Design chapter

• Replaced all references to "HV High Voltage" and "LV Low Voltage" with specific name of interface or wire

• Replaced "DC BUS (EXT A)" with "DC BUS (intake side)".

• Replaced "DC BUS (EXT C) with "DC BUS (exhaust side)".

• Created separate guides for NA vs EU. This is the NA guide.