Important Safety Instruction for Home (Flex) Products

SAVE THESE INSTRUCTIONS

This manual contains important instructions for Flex series stations. When using electric products, always follow basic precautions, including the following:

  1. Read and follow all warnings and instructions before installing and operating the ChargePoint® charging station. Install and operate only as instructed. Failure to do so may lead to death, injury, or property damage, and will void the Limited Warranty.

  2. Only use licensed professionals to install your ChargePoint charging station and adhere to all national and local building codes and standards. Before installing the ChargePoint charging station, consult with a licensed contractor, such as a licensed electrician, and use a trained installation expert to ensure compliance with local building and electrical codes and standards, climate conditions, safety standards, and all applicable codes and ordinances. Inspect the charging station for proper installation before use.

  3. Always ground the ChargePoint charging station. Failure to ground the charging station can lead to risk of electric shock. The charging station must be connected to a grounded, metal, permanent wiring system, or an equipment grounding conductor shall be run with circuit conductors and connected to the equipment grounding terminal or lead on the Electric Vehicle Supply Equipment (EVSEClosed Electric Vehicle Supply Equipment). Connections to the EVSEClosed Electric Vehicle Supply Equipment shall comply with all applicable codes and ordinances.

  4. Install the ChargePoint charging station using a ChargePoint approved method. Failure to install on a surface that can support the full weight of the charging station can result in death, personal injury, or property damage. Inspect the charging station for proper installation before use.

  5. This charging station is not suitable for use in Class 1 hazardous locations, such as near flammable, explosive, or combustible vapors or gases.

  6. This device should be supervised when used around children.

  7. Do not put fingers into the electric vehicle connector.

  8. Do not use this product if any cable is frayed, has broken insulation, or shows any other signs of damage. Call ChargePoint Support immediately at 1.888.758.4389 (24 hours).

  9. Do not use this product if the enclosure or the EVClosed Electric Vehicle connector is broken, cracked, open, or shows any other signs of damage. Call ChargePoint Support immediately at 1.888.758.4389 (24 hours).

  10. Use 90°C wire copper conductors only.

  11. Applicable only to NA - Do not operate the charging station in temperatures outside the operating range of -40˚F to 122˚F (-40˚C to 50˚C).

  12. Other than the charging cable, Flex Series charging stations contain no field serviceable parts. Do not attempt to repair or service any other part of the unit yourself. If the unit requires servicing, contact ChargePoint, Inc.

  13. Ensure the charging cable is positioned so it is not stepped on, tripped over, or subjected to damage or stress. Do not close a garage door on the charging cable.

Product Disposal

Proper Disposal iconChargePoint Flex Series stations are electronic and therefore may not be disposed of as part of unsorted domestic waste. Inquire with local authorities regarding proper disposal. Product materials are recyclable as marked.

Document Accuracy

The specifications and other information in this document were verified to be accurate and complete at the time of its publication. However, due to ongoing product improvement, this information is subject to change at any time without prior notice. For the latest information, see our documentation online at ChargePoint Product Reference Documentation.

Copyright and Trademarks

©2013-2026 ChargePoint, Inc. All rights reserved. This material is protected by the copyright laws of the United States and other countries. It may not be modified, reproduced, or distributed without the prior, express written consent of ChargePoint, Inc. ChargePoint and the ChargePoint logo are trademarks of ChargePoint, Inc., registered in the United States and other countries, and cannot be used without the prior written consent of ChargePoint.

Symbols

This guide and product use the following symbols:

Risk of electric shock
Risk of personal harm or death
Risk of equipment or property damage
Critical detail that must be followed to achieve intended results
Important contextual details or procedural clarifications
Essential instructions to follow when reinstalling a part or component
Read the manual Read the manual for instructions
Ground/protective earth Ground/protective earth

Illustrations Used in This Document

The illustrations used in this document are for demonstration purposes only and may not be an exact representation of the product. However, unless otherwise specified, the underlying instructions are accurate for the product.