Install or Replace Signs

Follow these steps to install signs on the charging station. To ensure a proper fit, signs must follow the specification provided by ChargePoint. An example of the sign specification (not to scale) is provided below. Detailed sign specifications for existing, optional, and custom signs are available at: ChargePoint Product Reference Documentation.

To ensure a proper fit, a replacement sign must be a maximum of 1 mm (0.04 in) thick and must be 102 mm (4 in) wide. The length depends on which version of the CMKClosed Cable Management Kit you are installing.

Installing a Top Sign on the CMK

To remove a sign after the station has been installed:

  1. Use the L-wrench to loosen the set screw on each side of the top cap.

  2. Pull the top assembly up and move it toward the back of the cord management assembly.

  3. Slide the existing sign out of the grooves.

To install a new sign:

  1. Slide the replacement sign into the grooves by bending it slightly. (Sample sign dimensions for a top sign are shown at right.)

  2. Slide the sign all the way down, ensuring its bottom edge is located behind the plastic cap on the cord management assembly.

  3. Re-install the top assembly. Tighten the set screws.

Installing a Rear Sign on a CMK

  1. Insert one of the long edges into the grooves along the side of the CMKClosed Cable Management Kit.

  2. Bend the sign slightly to insert the other long edge.

  3. Slide the sign all the way down until the bottom edge is against the bottom surface on which the station is installed.