Vehicle Communication Board

To replace the SEVBClosed Smart Ethernet Vehicle Board (Vehicle Communications Board) inside PD Controller, perform the following steps:

Required Tools and Materials

Tools

T20 Screwdriver

Orange and white icon that represents a tool or action.

Mobile elevating work platform (scissor

lift), as needed

Before You Begin

  1. Power off.

  2. Open the PD Controller.

Replace the SEVB

  1. Use T20 screwdriver, and loosen the screws (x2).

    Torque these screws to 1.13 Nm (10 in-lb).

  2. Disconnect the cables connectors (x7) from the SEVBClosed Smart Ethernet Vehicle Board.

  3. Lift the SEVBClosed Smart Ethernet Vehicle Board vertically to disengage it from the keyhole slots, then remove it from the mounting surface.

  4. Reverse the above steps to reinstall with replacement SEVBClosed Smart Ethernet Vehicle Board.

  • To adhere to ChargePoint best practices, complete the post-service checklist before you leave the site.

  • For assistance or to return a faulty part to ChargePoint, go to chargepoint.com/support and contact technical support using the appropriate region-specific number.