Replace the Cable Clamps

Required Tools and Materials

	CMK Cable Management Kit ball removal
	Torx screwdriver (T25)

Remove the Cable Clamp

1. Insert the service tool teeth into the two holes in the knot bearing and turn the knot bearing counterclockwise approximately 1/4 turn.

   

2. Use the T25 screwdriver to remove the screws (x2) that hold the top to the bottom of the cable clamp.

3. Remove the top and bottom of the cable clamp, along with the adhesive tape.

Install the Cable Clamp

1. Place the adhesive tape at the bottom portion of the new cable clamp.

2. Place the new bottom of the cable clamps on the cable underside of the cable in the same place as the old cable clamp.

3. Place the new top of the cable clamp on the topside of the cable to match the bottom of the cable clamp.

   

4. Verify that the top of the cable clamp (the flat portion) is correctly oriented to the top of the charging cable.

5. Use the T25 screwdriver to tighten the screws (x2) that hold the top to the bottom of the cable clamp.

6. Match the knot bearing on each rope to the corresponding mating feature on the cable clamps.

7. Insert the service tool into the two holes in the knot bearing clockwise approximately 1/4 turn. You may need to push it down while turning the knot bearing.

   

   Ensure no gap exists between the top cap and the ball.