Replace the LED Display

To replace the LED display, complete the steps in this chapter.

Required Tools and Materials

Tools and Materials

Head lamp

T25 Torx security screwdriver

ChargePoint replacement part #CPE250-LEDDISPLAY-F

    

Before you Begin

Complete the following procedures:

  1. Power Off the Station.

  2. Remove the Area Light Bar.

  3. Remove the LED Display.

Install the LED Display and Area Light Bar

  1. While holding the new LED display near the opening at the top of the Express 250, connect its five cables to their connectors on the back of the display. Leave the area light bar cable (e) loose.

    1. Communications cable (USBClosed Universal Serial Bus-A)

    2. Holster light cable

    3. Area light cable x 2 (interchangeable)

    4. Power cable (24 V)

    Before continuing, ensure all five cables are properly connected. Do not allow the LED display to hang from the cables once they are connected.

  2. Angle the top edge of the LED display under the light bar on the Express 250.

  3. Starting at the top, align and slide the LED display guide tabs into the corresponding slots. Ensure the lower sign is correctly captured by the bottom edge of the LED display.

  4. Push the bottom into place until firmly seated.

    5. Keep the area light cable routed out the top of the display.

REVERSE THE ABOVE STEPS TO REPLACE THE AREA LIGHT BAR.

Power On the Station.